ACTIVITY 1

ACTIVITY 1

  LED GLOW USING BATTERY

 

Software Requirements:

  • Autodesk eagle

Components Requirements:

  • 9v battery
  • LED (any color)
  • Resistor( 330 ohm)

STEPS:

  • open the Autodesk Eagle software.
  • in control panel page open < file< new< schematic.
  • In Schematic Editor, click on add tool, and select the particular components( for eg LED)
  • Repeat the step for the next components.
  • place the components properly
  • select wire button and wire up the components as per the circuit diagram
  • RUN ERC( if any error, remove them first before moving to the board section)
  • switch on to the board section.
  • make the proper dimension
  • place the components properly
  • select on route button and state routing
  • when routing is done, make ground plane .
  • RUN DRC
  • generate gerber file