Let’s see how we use an LED in our first project i.e., Table lamp.
In this project we will require the following components:
Power – 1
Bright Led -1
Gray plate -1
CT2 – 4
Power bank – 1
USB to DC jack -1
Let’s start with the circuit.
Take the Power block.
Connect a Bright LED to it.
Take 4 CT2 and plug it at the bottom holes of the Power Block and the Bright LED. Remember to plug the CT2 in every hole.
Now place the circuit on the Gray plate.
Connect the power bank to the Power block using USB to DC Jack.
Now turn on the slide switch of the Power block to light up the Bright LED!
Always switch on the slide switch at the end, only after you have connected all the blocks and components properly.
Try replacing the LED with a Buzzer and see what happens.
Username or Email Address
Password
Remember Me